We are trying to replace the light in our late-60s era swimming pool. Our electrician told us in advance that new 8" lights were no longer available so he was going...

I am considering installing a new inground pool in Phoenix Az. I have read all of the pros and cons both for and against each type of pool. What I want to know now is if...

I recently purchased a 18 X 33 above ground pool. The site for the installation has roughly a 35" difference in elevation over the span of 33 feet. Knowing I have a...

Hi everyone,

We just bought a house in N. phoenix and the builder recommended Shasta pools to do the construction. However, I'm having some issues with their...

Rought estimate to hook up pool? The electrician needs to run wire from the house to "sub-panal" at pad, hook up: pool pump, pool cleaner pump, heat pump,...

I am planning on putting in a fiberglass pool from Leisure Pools in San Antonio, anyone have experiences to share, good or bad..?

Or anyone have any other...

I have a pool that I just took down that needed to be replaced due to age. I have bought a new pool and was going to have it installed in the same area as the old pool...

MY steel above ground pool is not level by about 3 inches on one end. Is there any danger with this?

When mixing shock with water in a bucket, I spilled some on the rock on the edge of the deck. It turned black. What can I do to get it back to the light brown. This may...

swimming pool

We are getting ready to have a 24' x 52" deep round above ground pool put in. My dh wants to have a 6" concrete pad poured first. I think 4" would be...

I am putting in a pool and it measures 20 x 40. I would like to put in place 4 Jandy Laminar Pool Jets.. The furthest jet will be 75 feet away from the equipment. Iam...

Hello,

My liner pool was completed in October of 2004. We live on hill and had a retaining wall on the back side. The wall and half of the pool deck and foundation...

Is is possible to change an inground pool from vinyl to stainless steel?

I've been told by a pool company that they can not feasibly begin the pool creation (excavation to completion) process in the winter months. I asked how about March? (I...

We just had our pool replasterd but the surface has some rough spots. The company that did the work agreed to fix it but they want to sand it smooth. This sounds ok to...

My family is in the process of installing an inground pool. I have decided to blog the whole event. If you are interetsed, the address is...

I know this has come up before but no real answer yet so...PB said he does not install Main drains in fiberglass pools any longer. He said water is pumped from skimmer...

I am DIY building a polymer wall pool. The are is very tight and I am trying to firgure out how to get the concrete around the outside perimeter of the pool walls. My...

I've just had an old marcite plastered pool redone with Florida Gem (3M Quartz product) and new waterline tile. The pool was originally built in 1973 and I know little...