I am having my electrician and pool people setup my system this week and I wanted to be clear on how the setup should go before they get here that way I can make sure...

I was wondering if anybody knows if these can be replaced or if there is something else you can use for this. I bought a used pool and the not all of the straps are...

I have received a few bids for a new inground gunite pool to be located in the southwest and left open all year. The company I am considering constructs the pool with...

Most of my neighbors used a water supply company to fill their pool. I'm trying to decide on the same company or fill using my garden hose. The water will come from our...

I have two lights in the IG pool. On for the main pool, and another for the spa attached to the pool.

There is a 30 AMP braker on the main panel, going to the pool....

I have a 20-year-old-plus plastered gunite pool whose surface has gotten discolored and rough - really tough to keep clean. It's got two vertical cracks - one on each...

We are trying to replace the light in our late-60s era swimming pool. Our electrician told us in advance that new 8" lights were no longer available so he was going...

I am considering installing a new inground pool in Phoenix Az. I have read all of the pros and cons both for and against each type of pool. What I want to know now is if...

I recently purchased a 18 X 33 above ground pool. The site for the installation has roughly a 35" difference in elevation over the span of 33 feet. Knowing I have a...

Hi everyone,

We just bought a house in N. phoenix and the builder recommended Shasta pools to do the construction. However, I'm having some issues with their...

Rought estimate to hook up pool? The electrician needs to run wire from the house to "sub-panal" at pad, hook up: pool pump, pool cleaner pump, heat pump,...

I am planning on putting in a fiberglass pool from Leisure Pools in San Antonio, anyone have experiences to share, good or bad..?

Or anyone have any other...

I have a pool that I just took down that needed to be replaced due to age. I have bought a new pool and was going to have it installed in the same area as the old pool...

MY steel above ground pool is not level by about 3 inches on one end. Is there any danger with this?

When mixing shock with water in a bucket, I spilled some on the rock on the edge of the deck. It turned black. What can I do to get it back to the light brown. This may...

swimming pool

We are getting ready to have a 24' x 52" deep round above ground pool put in. My dh wants to have a 6" concrete pad poured first. I think 4" would be...

I am putting in a pool and it measures 20 x 40. I would like to put in place 4 Jandy Laminar Pool Jets.. The furthest jet will be 75 feet away from the equipment. Iam...

Hello,

My liner pool was completed in October of 2004. We live on hill and had a retaining wall on the back side. The wall and half of the pool deck and foundation...

Is is possible to change an inground pool from vinyl to stainless steel?