Hello experts,

My neighbor is complaining that my Hayward's HeatPro Heat Pump is noisy. The unit is 3years old.

I am looking for a simple way to...

Once I connect my vacuum hose to the dedicate inlet hole on the inside of the pool air bubbles start to come out of my return valves. I have made...

Having a very hard time keeping chlorine levels up in pool. Could the swg be bad or is it most likely chemical issues??

I have a pool that was built in 1976 and the bulb has water in it. I can not find any screws to remove the assembly from the pool side wall. There is...

We have a vinyl liner pool with 35,000 gallons water. We have shocked the pool several times with as much as 13 bags of shock and have also used...

Pump is broken and new pump is a 7 day wait, and above ground pool is getting mosquito larvae!
What can I do while waiting for pump? Thanks so much!...

Hi all

We moved into a house with a pool around 6 years ago having never owned a pool before.

It's been one issue after another (new boiler only...

I sure hope someone can help me! Our pool has worked fine for the last 2 years. We have a 15X30 oval above ground pool with a Hayward filter and a...

Any help with my problem with be greatly appreciated. I have a 24ft above ground non chlorine pool w/sand filter. Instead of chlorine I use a...

I think I put too much Algaecide (total 2 L - 2 bottles of 1 L each) in the pool which generates a lot of foam. The algaecide I use is Sani-Marc...

I know when it's hot there is a lot of evaporation of water, but this year seems to be much worse - water level dropping between 2-3 inches a day -...

I have never had this problem before and it appeared only this year. All along the bottom sides and bottom along the sides there is a strip of what...

Who would you recommend for a Commercial pool remodeling project in Chandler n Arizona?

I have a 35,000 litre pool.

Specs are:
Freshwater
Chemigen DM5S
Intellicom Communication Center
Waterco S702 filter
Polaris Jet Cleaner
Viron 250mj...

Can some one help please? I have an 8m x 4m pool (fresh water) which has an average depth of 1.3m. The pool has been in operation for only two years....

I have over the last few months had a thick layer of sludge buildup in the first few centemeters of the sand in the filter. back flushing water runs...

I can't afford to run the pool this year. So it's just sitting there with the cover on. it's an inground concrete pool - pretty big with a curved...

whle starting to vacum pool my pump loses suction in less than a minute, basket on pump loses its water, after removing vacum hose and running pump...

What should be the minimum size of swimming pool?

I have a
14x32 inground pool I have coming out returns sometimes also isome bubbles under pump there is no visible leaks anywhere
Help!!!