HELP!!!! my cyclone sand filter is 1 yr old and when i uncover it this year the words on top are gone faded out. Mine has 7 settings and everyone either owns or sells...

I have nine solar panels on the roof, and a Goldline Aqua collector with a Jandy valve actuator. There is a sensor on the roof attached to a panel. My problem is, when I...

Air bubbles coming out with the water from the filter???

Hi, newby here... I have a Dolphin Diagnostic which is the best, no problems over here... long story short, the side with the electrical cord is cracked, I have replaced...

Hi, We have an aqua logic saline pool. Sometimes when we turn on the chlorinator, the pool will shut off. If we turn the chlorinator off, it stays on... any suggestions?

Swimming pool designs range from the very small and basic inflatable pool to the grandiose and extravagant inground designs that at first glance look like a natural body...

Technical Question... Please

My pool gets 11 inches of rain, but the water level does not exceed the top of the skimmer. There must be an overflow, but I cannot find...

Hi,
I maintain a fiberglass pool that started to discolor in August. Testing indicated NO Iron and .3 Copper. A second test, poolside, using a metal testing granules...

Note to Admin: All at once I am unable to either sign in or register at your principal site

...and so I wonder if you could look into the problem. Perhaps there's...

Hello,
I was told I could clean my salt water cartridge filter with muratic acid, how do I do it?
Please help
Thank You,
Phil

My pump is Whisper flo 3/4 hp. can i upgrade motor to 1.5 hp.
Thank you

I would like ideas on how to mark the bottom of my pool without draining it. I want to swim laps with my head straight down rather than looking forward. My pool is wide...

Cannot get chlorine to stay in pool

Put in 5 lbs of Bioguard 99% - next day 0 chlorine

Put in 3 bags of burnout – same thing

Salt generator is working, but no...

I have a Mineral Springs MS 10 or 11. The unit display always showed salt in PPM then the Temp. It just stopped. Is that tied to the flow indicator or??????????????

It...

Air bubbles in water returning to pool. When pump shuts off massive air blows out of the skimmer.

our psi is reading 20 to 25. we are having some problems with our pool since this started. what could be causing this to read high? also being that this is this high...

Last year my 5 year old daughter started having very painfull stinging urniation after swimming in our pool. We used it today for the first time this year and she had...

When we opened our pool today we found there were 2 screwdriver bits left on the bottom of the pool sitting and corroding on the liner. These were left by the guys who...

Anybody have some troubleshooting options for reassembling a Hayward Northstar 1.5 motor?? I cannot get it 1/2 inch into pump....pool is already having problems and I...

i have a hayward navigator thats only picking up half of the dirt, i've checked all of the filters and even had the unit rebuilt and tested on another pool... what next...