pump motor problem?

Tips and problems concerning filling new pools.
Spring pool opening and fall pool closing.
Seasonal pool maintenance tips & advice.
I'm new here
I'm new here
Posts: 1
Joined: Mon 28 May, 2007 11:06

pump motor problem?

Postby sueandchris » Mon 28 May, 2007 11:20

We opened our inground pool today - went through the normal routine - However, when we turned on the filter nothing happened. We can hear a buzz indicating the electricity is on but there is no other sign of life. It's a Hayward sand filter and it's only about 3 years old. Could this be a pump motor problem?
Thanks for any advice before we call the very expensive pool guy!

Swimming Pool Superstar
Swimming Pool Superstar
Posts: 257
Joined: Thu 23 Nov, 2006 17:23
Location: Perth, Western Australia

Postby dynamictiger » Mon 28 May, 2007 17:23

A buzz can indicate a motor problem or a pump problem. It could be the pump impellor is jammed for some reason or the capacitor on the motor has failed or worse the windings in the motor have failed.

Looking at the motor there is usually a fan cover on the non drive end. In teh centre of the fan cover there is normally a hole and the motor shaft can be seen through this hole. Try turning the motor shaft using a screwdriver and see if it spins freely. If it does chances are you have an electrical fault like the capacitor, if not you most likely have a jammed pump.


Return to “Opening / Closing / Winterizing the Pool”

Who is online at the Pool Help Forum

Users browsing this forum: CommonCrawl [Bot] and 0 guests