Intex Saltwater System NO FLOW error

SWGs, salt water chlorine generators, chlorinators,
ozone generators, UV systems, . . .
poolforumuser123

Re: Intex Saltwater System NO FLOW error

Postby poolforumuser123 » Mon 27 Jun, 2016 00:49

Make sure the unit is level (or at a minimum raised on the exit flow slide) or the bubbles may build up and float stream in the direction of the flow sensor.


pooluser123

Re: Intex Saltwater System NO FLOW error

Postby pooluser123 » Sat 13 May, 2017 13:51

My white flap was backwards the circle should be facing out towards the pool and when the water is flowing it should face. FYI the circle is the raised bit on one side and on the other side you have the lip on the edge. the lip is supposed to catch the water better so that is lifts the white thing up as high as it will go so the sensor will detect it.
pooluser1234

Re: Intex Saltwater System NO FLOW error

Postby pooluser1234 » Sat 13 May, 2017 13:54

My white flap was backwards the circle should be facing out towards the pool and when the water is flowing it should face up and touch the top toward the plug. The circle is the raised bit on one side and on the other side you have the lip on the edge. the lip is supposed to catch the water so that it lifts the white thing up as high as it will go so the sensor will detect it.

Return to “Salt Water Chlorine Generators, Ozone, UV”

Who is online at the Pool Help Forum

Users browsing this forum: CommonCrawl [Bot] and 3 guests