Replace PCB for firmware 1.4?
Replace PCB for firmware 1.4?
I'm looking to replace my dead salt cell on an aqua rite control board. The pool is only 8000 gallons, but I've got a Hayward t-15 hooked up to it with software version 1.4. After talking to an agent at Hayward they said I could only replace it with a t-15 because of how old the software is but that the t-15 would "probably last longer" because I wouldn't be demanding the full use of it. Can I replace the PCB to give myself software version 1.5 and allow me to use the generic replacements from pool supply world or even a t-5 or t-3? And is that worth it? What is more cost efficient in the long run?
-
- Pool Industry Leader
- Posts: 2594
- Joined: Tue 06 Sep, 2011 05:48
- My Pool: 10k inground fibreglass, Telescopic Cover, Hayward Powerline pump, Quality filter with glass media, 27kw output heat pump, K-2006C test kit
- Location: United Kingdom
Re: Replace PCB for firmware 1.4?
I can't tell you about the software and PCB but the general rule of thumb for sizing is to go for a 2 x your gallonage or larger
This is so your cell isn't running flat out all the time and you have plenty in reserve. Your T15 could run at 20% most of the time making it last longer
This is so your cell isn't running flat out all the time and you have plenty in reserve. Your T15 could run at 20% most of the time making it last longer
-
- I'm new here
- Posts: 1
- Joined: Fri 20 Sep, 2019 16:46
- My Pool: 27,000 gallon, zero edge, 6 Pentair pumps, built by Andersen Pools
Re: Replace PCB for firmware 1.4?
Has anyone found a resolution for this issues? My firmware is 1.4 and I need to upgrade to 1.5 in order to use a generic salt cell. Do I really need to replace the pcb? Seem ridiculous for software update.
Return to “Salt Water Chlorine Generators, Ozone, UV”
Who is online at the Pool Help Forum
Users browsing this forum: No registered users and 8 guests