I have the Aqua Rite system and it has been working good (for the most part) over the past three years. Recently, however, is has lost communication with the Jandy AquaLink RS4 panel. I contacted Goldline Controls and received the standard answer of "you need a new control board". Since everything else is working well I wanted to run this by the forum before spending $$$s.
So...any suggestions on how to get the two units to communicate again? If a new board is required, is this a user-friendly replacement? I don't mind digging in if it saves money.
Thanks
Aqua Rite to Aqualink Connection
-
- I'm new here
- Posts: 1
- Joined: Wed 20 Aug, 2008 16:35
Aqua Rite to Aqualink Connection
check on Manulabo.com/hayward for your help.
OR
www.goldlinecontrols.com/Support/refgui ... ration.pdf
Have fun !!!
OR
www.goldlinecontrols.com/Support/refgui ... ration.pdf
Have fun !!!
Return to “Salt Water Chlorine Generators, Ozone, UV”
Who is online at the Pool Help Forum
Users browsing this forum: No registered users and 19 guests