has anyone troubleshot the "pcb" error code on the aqua-rite control panel?
i was hoping someone could direct me in my troubleshooting today. looking for specific failures on the pcb rather than, "sorry sir, an authorized technician will have to replace the whole unit"
"pcb" code on aqua rite control panel
"pcb" code on aqua rite control panel
The inthruster is the most common problem. It is in the top right corner of the pcb. It is black and size of a quarter. Look for burn marks around where it is soldered or if it is cracked. To find a replacement go online to Digi-Key.com the cost is 2.42 plus shipping! This fixed my problem I hope it helps you.
"pcb" code on aqua rite control panel
The current limiter Inrush located in the top right corner of the pcb is the problem I had. Look to see if ther are any burn marks, or if the black disk the size of a quarter is cracked or the solder has come loose. If the disc is bad, a new one can be found at Digi-Key.com The part number is 570-1062-ND The cost is 2.42 plus shipping! This was my problem I hope this helps you Too! Way better than paying a service call or buying a new circuit board.
"pcb" code on aqua rite control panel
Thank you both for this tip! $2.62 vs $299.00 for a new board! Awesome!
Return to “Salt Water Chlorine Generators, Ozone, UV”
Who is online at the Pool Help Forum
Users browsing this forum: No registered users and 19 guests