Pressure Gauge

Pool pumps, pool filters and the plumbing of
swimming pools. Sand filters, cartridge filters,
fabric filters and alternative filter media.

Pressure Gauge

Postby mmtimoteo » Tue 14 Jun, 2005 19:43

when i turn on the filter, the pressure gauge is still on zero and i dont see any water running, i only hear the motor running... please help

Pool Care Proficient
Pool Care Proficient
Posts: 37
Joined: Mon 06 Jun, 2005 07:21
Location: Turkish Republic of Northern Cyprus


Postby vaughanwilliams » Wed 15 Jun, 2005 07:07

Check your multi-port valve is in the corect position. Try a few options like backwashing, rinsing, circulating as well as filtering. If you can't get any water to flow in any position, either you have a suction valve(s) closed or your impeller has come off your pump.

Vaughan Williams
Technical Director
Octopus Pools

Postby Guest » Tue 21 Jun, 2005 14:19

is this after opening the pool??? Did you prime the pump? I find that the pump tends to suck a lot of air when not primed properly. I also have the drain plugs removed on both the filter and pump when I close the pool, so I have to make sure they are put back before starting the pump.

Postby doubled1 » Fri 24 Jun, 2005 05:27

Install new gauge

Postby doubled1 » Fri 24 Jun, 2005 05:27

Install new gauge
I'm new here
I'm new here
Posts: 1
Joined: Sun 13 Nov, 2016 10:10
My Pool: Model NO.: SW001
Seating Capacity: 8 People
Control Way: Hand
Size: Big
Material: Ceramic
Fiter System: Integrative Filter or Single Filter for Selection
Heating Sytem: Different Power Selection According to Pool Size
Disinfection System: Traditional or Modern Disinfection
Trademark: FANLAN

Re: Pressure Gauge

Postby viliam » Sun 13 Nov, 2016 10:11


Return to “Pool Pumps, Filters, Plumbing & Piping”

Who is online at the Pool Help Forum

Users browsing this forum: CommonCrawl [Bot] and 5 guests