So I just upgraded my pool controls to Pentair Easytouch 4. Did it my self, and so far, so good. This is a house I bought a few years ago, and the pool pump is a 2 speed Century pump, which up to now has only operated on one speed.
As part of the EasyTouch install, I re-did all the wiring and on the pump, there were 4 wires, one of which wasn't connected on either end.
The terminals on the pump are listed as "L1", "L2", "A", and one for "G"round.
Now I have the 2 speed Pentair relay, and it calls for three wires(I'm assuming L1, L2, and A) but is looking for "Hi" "Lo", and "Common". So I have 3 labels on the pump and 3 labels on the relay, and they don't match.
Just curious if anyone knows how I should connect the wires to the relay.
2 speed pump
Return to “Pool Pumps, Filters, Plumbing & Piping”
Who is online at the Pool Help Forum
Users browsing this forum: No registered users and 21 guests