I have completely rebuilt my pool vac and tested all the hoses.
It will run for days and days on either the:
1. skimmer 2. vacuum connection 3. main drain.
However, about 1 to 2 minutes after I connect the pool vac hose, the water flow into the pool is greatly reduced and the pool vac stops. There doesn't seem to be a great amount of air in the system.
Help please. Thanks very much
Out of ideas!
Out of ideas!
Does it run with only the hose but no vacuum attached? Sounds like a leak in the vacuum hose or you are not priming the hose and it takes such a big gulp of air the pump loses prime and just stops pumping.
Return to “Pool Pumps, Filters, Plumbing & Piping”
Who is online at the Pool Help Forum
Users browsing this forum: No registered users and 11 guests