Hello,
I recently had a leak detected underground associated with one of the jets in the spa and had it repaired immediately. Prior to the repair service, the jets in the spa had a decent output of water and the blower functioned fine, creating a typical bubbling spa. After the service, I now have low volume of water coming through the jets and the blower comes, but no bubbles come through the jets. The company that repaired the leak say that they did nothing in their service to cause this problem. Is this a correct statement on there part and/or is there any information that can be provided to help me understand the this problem? Any guidance would be greatly appreciated, thanks.
Low output through spa jets
Low output through spa jets
Either they replumbed the system or they narrowed the pipes.
What more can you tell us about the location of the leak and the nature of the repair?
What more can you tell us about the location of the leak and the nature of the repair?
Low output through spa jets
The repair was done on the outside of the spa wall, about 6 inches from the wall itself. The leak detection company told me that the flex pipe pulled away from the joint due to deck settling and that is were the leak occurred. To my knowledge they did not change any of the piping. Also, this is a relatively new home and pool/spa. They were all constructed three years ago.
Low output through spa jets
the flex pipe pulled away from the joint due to deck settling
That is very common, but a repair shouldn't result in losing pressure. Could there coincidentally be a problem with pump or the suction line?
Return to “Pool Pumps, Filters, Plumbing & Piping”
Who is online at the Pool Help Forum
Users browsing this forum: No registered users and 34 guests