I have a Pentair Intelliflo Pump and Mastertemp 400 Heater. Pool setting is 18 PSI, spa is reading the same. Not enough PSI for the heater to kick on. I replaced the pressure switch, cleaned filters, checked impeller and skimmers for debris with no luck.
Any additional troubleshooting ideas?
Spa Heater says Service System
-
- I'm new here
- Posts: 1
- Joined: Thu 11 Nov, 2021 19:28
- My Pool: Avg sized pool w/ spa with salt chlorinator. Remodeled with new equipment in 2012 - Pentair Intellifo Pump, Pentair Mastertemp 400 Heater.
-
- Pool Industry Leader
- Posts: 1206
- Joined: Thu 29 Apr, 2021 00:43
- My Pool: 12000 gallons vinyl liner,
Re: Spa Heater says Service System
My pool runs at 0.5 PSI with a clean filter, replaced pressure switches with flow switches for obvious reasons. You don't need that kind of pressure, its an open circuit. This is internal pressure which in reality is just costing you a lot in electricity, often caused by a too smaller filter and too larger pump. It worsens the filtration so all in all achieves less.
I may not give you the answer you want to hear, but I will give an honest opinion of your situation as you decribe it.
Return to “Pool Equipment & Other Pool Maintenance”
Who is online at the Pool Help Forum
Users browsing this forum: No registered users and 18 guests