I have a Purex Triton filter and 6-way valve. The old gasket was flat on the top (and bottom). I can't seem to find a replacement gasket that is flat on both sides. The top side has a ridge. When I put a ridged gasket in, the valve handle has a large amount of play (loose, it flops up and down).
The pool is only 8 years old and the pool company that installed the pool said they have never seen a flat gasket.
Has anyone else had this problem?
Has anyone seen a gasket with a flat top?
Spider Gasket Question?
-
- Pool Enthusiast
- Posts: 26
- Joined: Tue 15 Jun, 2010 12:50
- My Pool: my pool is kidney shaped and about 12,000 gallons
- Location: Orange County
Spider Gasket Question?
Send a picture of the backwash valve and perhaps someone will find the right gasket.
Good luck,
Rob
Good luck,
Rob
YakMan wrote:I have a Purex Triton filter and 6-way valve. The old gasket was flat on the top (and bottom). I can't seem to find a replacement gasket that is flat on both sides. The top side has a ridge. When I put a ridged gasket in, the valve handle has a large amount of play (loose, it flops up and down).
The pool is only 8 years old and the pool company that installed the pool said they have never seen a flat gasket.
Has anyone else had this problem?
Has anyone seen a gasket with a flat top?
Return to “Pool Equipment & Other Pool Maintenance”
Who is online at the Pool Help Forum
Users browsing this forum: No registered users and 26 guests