My back wash valve is dying/dead What should I do?

Discussions that do not fit into any of the
swimming pool categories and general topics.
iNISSANt
Pool Newbie
Pool Newbie
Posts: 3
Joined: Thu 17 May, 2007 20:00

My back wash valve is dying/dead What should I do?

Postby iNISSANt » Thu 17 May, 2007 20:25

It is a 20-25 Year old Anthony Sylvan Brass Push/Pull pump valve
www(dot)poolcenter(dot)com(backslash)parts_valves_anthony_pools_apollo(dot)htm

The Tank is the same age Anthony Sylvan Apollo DE Filter
www(dot)poolplaza(dot)com(backslash)C-Anthony-Apollo-Filter-Parts(dot)html

1.) Should I replace the the Backwash Valve given the age of all of the equipment. I cannot replace it with a direct replacement because it is no longer available. I can rebuild the shaft and seals for 100-200.

2.) Should I replace the back wash valve with an entire new modern assembly? Any Ideas what valve brands are good? Which ones would require the least amount of work to retrofit?

3.) Should I bite the bullet and replace the Tank with new motor etc...
What brands are good? I was interested in a Hayward Model that allows "bump cleaning of the DE" to reduce loss of treated water.


Any help would be greatly appreciated.


sparkwatercleaner

Postby sparkwatercleaner » Sat 19 May, 2007 21:35

How old is your equipment?
Buggsw
Swimming Pool Superstar
Swimming Pool Superstar
Posts: 421
Joined: Sun 13 May, 2007 23:26

Postby Buggsw » Sun 20 May, 2007 19:01

Well if that isn't a testament to that equipment. My goodness, over 20 years old.

Personally, I would replace the filter and valve. If the pump is still okay, I would leave it alone until it died.
iNISSANt
Pool Newbie
Pool Newbie
Posts: 3
Joined: Thu 17 May, 2007 20:00

Postby iNISSANt » Tue 22 May, 2007 19:39

Well I decided to have a highly reccomended pool guy look at it.

It turns out that it is just the valve. He is going to replace the shaft, orings and handle. He said that he has the same valve and filter on his pool. He also said he wouldn't be suprised if it lasted another 10 years or more.

Thanks for the input.
Guest

My back wash valve is dying/dead What should I do?

Postby Guest » Tue 12 May, 2009 16:38

How did this turn out for you? I am in the exact same situation with the same Anthony system and wondering if i should replace the valve or think of replacing the entire system.
User avatar
mr_clean
Swimming Pool Superstar
Swimming Pool Superstar
Posts: 398
Joined: Thu 16 Aug, 2007 14:32
Location: So Cal

My back wash valve is dying/dead What should I do?

Postby mr_clean » Sun 31 May, 2009 11:44

it works out good & for under $100, and you do not allows have to replace shaft but only the o-rings which is even cheaper. The old brass backwash valves normally have a top that is bolted down or screws off, so once you take off it pulls out & you will see fato-rings that need replacing.

Return to “Poolside - General Discussions”

Who is online at the Pool Help Forum

Users browsing this forum: No registered users and 5 guests