New Bod, empty dirty pool - where do I start?

The basics of swimming pool maintenance.
New swimming pool owner's questions.
Help getting started with daily pool care.
trenery
Pool Newbie
Pool Newbie
Posts: 2
Joined: Mon 19 Mar, 2012 07:58
My Pool: 3m x 6m x 1.5m (7000 us Gals, 27,000L)
In ground, liner, sand filter.
Usually under 10 degrees C Brrrrrr. Fitting solar this year.
Location: Newbury, UK

New Bod, empty dirty pool - where do I start?

Postby trenery » Mon 19 Mar, 2012 08:25

OK, so here it is. My first pool which has just been inherited by a house move. It hasn't been used for about 4 years. At first it looked fine but after taking the winter cover off we quickly discovered 12" of algae and slush on the bottom. So we drained it, got the newts out and gave it a good jet wash.

It is an in ground liner pool 3m x 6m x 1.5m (roughly 7000 US Gals). There is a sand filter and I am just about to replace the sand.

A have loads of questions and after trawling the internet and this forum and I am even more confused as to which way I should go. But I hope you can help me with a few initial questions.

1) Should I clean the stained liner with a bleach solution and scrub it before filling with water?
2) Once filled, do I need to shock it or just add a stabilised chlorine until I get a stable 3ppm
3) Should I use baking soda to get TA to 100'ish before adjusting PH?

I assume that once CYA is over 30 I can switch over to bleach.

Any assistance greatly received.

Thanks

Mike


cpo2go
Swimming Pool Wizard
Swimming Pool Wizard
Posts: 67
Joined: Wed 20 Jul, 2011 01:09
My Pool: 27,000 gal, pebble tec, all Pentair equipment; DE filter, 3/4 hp, 400k heater, Poolvergnuegen 4x Pool Cleaner
Location: santa barbara, ca

New Bod, empty dirty pool - where do I start?

Postby cpo2go » Wed 23 May, 2012 12:28

Your plan of attack sounds good to me. I don't have a tomn of experience with vinyl liners but, if you haven't found anything specific for cleaning them, I think that's fine. I would do more research on that, though, just because I would if it was my pool.
Once filled, you don't actually need to 'shock' the water. Test your fill water befopre it goes in to get a starting point. You definitely want to get your alkalinity right before you adjust pH. Good call! You've obviously learned more than you thought from these forums.
Good Luck!!
http://www.cpo2go.com
Pool and Spa Water Care Simplified.
Easy to use, fast results.

Return to “Basics for New Pool Owners”

Who is online at the Pool Help Forum

Users browsing this forum: No registered users and 0 guests