Aqua Rite to Aqualink Connection

SWGs, salt water chlorine generators, chlorinators,
ozone generators, UV systems, . . .
swfl_outdoors
Pool Newbie
Pool Newbie
Posts: 1
Joined: Wed 20 Aug, 2008 16:35

Aqua Rite to Aqualink Connection

Postby swfl_outdoors » Wed 20 Aug, 2008 16:53

I have the Aqua Rite system and it has been working good (for the most part) over the past three years. Recently, however, is has lost communication with the Jandy AquaLink RS4 panel. I contacted Goldline Controls and received the standard answer of "you need a new control board". Since everything else is working well I wanted to run this by the forum before spending $$$s.

So...any suggestions on how to get the two units to communicate again? If a new board is required, is this a user-friendly replacement? I don't mind digging in if it saves money.

Thanks


manulabo

Aqua Rite to Aqualink Connection

Postby manulabo » Fri 25 Jun, 2010 15:17

check on Manulabo.com/hayward for your help.

OR

www.goldlinecontrols.com/Support/refgui ... ration.pdf

Have fun !!!

Return to “Salt Water Chlorine Generators, Ozone, UV”

Who is online at the Pool Help Forum

Users browsing this forum: No registered users and 0 guests