I have an Aquarite about 6 years old.
I have NO display, the 4 leds (Low Salt, High Salt, No Flow, Inspect Cell) are flashing.
I tested the PCB with a VOm and have 240v at the board.
The fuse is not blown.
The pump is working.
Unfortunately, I do not have a "PCB" error because I have NO display, (and blinking lights NOT solid lights) so I am not sure if I should replace the:
a. Main PCB Board - ~$200
b. and / or Digital Display ~$160
c. Transformer (Can't even find a rpl part# for this) $ no clue
d. Whole panel ~$500
I am leaning towards the PCB but the no display has me concerned.
Any help or technical info would be appreciated.
I am fairly technical although I have no real experience with pool equipment.
Also, if you have a better source for parts, I am open to them as well
TY
Aquarite - No Display - 4 Flashing Lights - Fuse Ok
Aquarite - No Display - 4 Flashing Lights - Fuse Ok
First things first. Make sure the board is setup for 240v and not 120v
APSP Certified Service Pro
Jandy Tech School
Pentair Tech Training
Raypak Heater School
5 yrs experience
Jandy Tech School
Pentair Tech Training
Raypak Heater School
5 yrs experience
Aquarite - No Display - 4 Flashing Lights - Fuse Ok
Well, I was right. It was a bad PCB Board.
Aquarite - No Display - 4 Flashing Lights - Fuse Ok
Aquarite "PCB" display- All 4 Lights On-
Replace PCB display or Main Panel Board?
Replace PCB display or Main Panel Board?
Return to “Salt Water Chlorine Generators, Ozone, UV”
Who is online at the Pool Help Forum
Users browsing this forum: No registered users and 2 guests