Solar blankets / covers: blue vs. silver back vs. clear

Automatic pool cleaners, vacuum heads, pool covers,
decks, fencing, pool alarms and security ....

Solar blankets / covers: retractable?

Postby jlfitzpatrick » Mon 30 Jan, 2012 19:25

I don't use my 16 x 43 foot inground pool as much as I would if the solar cover could be easily retracted by one person. I hear nothing good about the "hand wind" devices. I LOVE my blue solar cover and need it in CT. Anybody have an electrically or mechanically retractable cover that works - or know of such? Thanks in advance.

chem geek
Pool Industry Leader
Pool Industry Leader
Posts: 2382
Joined: Thu 21 Jun, 2007 21:27
Location: San Rafael, California

Solar blankets / covers: blue vs. silver back vs. clear

Postby chem geek » Tue 31 Jan, 2012 11:02

I have an electric mostly opaque safety cover from Pool Covers, Inc. as shown closed and open . We now have a dark blue one instead of the tan one shown in the photos. The cover seems to need to get replaced every 3-4 years while some of the hardware gets replaced after 7 or so years. So it's not cheap and one should figure that on average in the San Francisco Bay Area it's around $350 per year (in peaks of $700-$1200) so more expensive than replacing a bubble-type cover every couple of years. That's the price for convenience.

My chlorine usage is a lot lower even though the pool is used everyday (in the summer) with < 1 ppm FC per day chlorine demand. Most residential pools without a cover exposed to sunlight have 2-3 ppm FC per day chlorine usage.

Unfortunately, I don't know who does electric solar cover installations in CT.

Solar blankets / covers: blue vs. silver back vs. clear

Postby John75 » Sat 10 Mar, 2012 19:29

Hi Bailey! Have you checked this guide to swimming pool covers at
Duke of Joke

Solar blankets / covers: blue vs. silver back vs. clear

Postby Duke of Joke » Wed 02 May, 2012 00:07

[I use my pool vac under the cover to really move the water around on real hot days!][/quote]
Joseph2010 wrote:I see Folks are confused as to How to get the most from their Solar cover.
Know that having your cover sit in the Sun AND that chlorine will break down your cover. Don't over chlorinate and either cover it or get it out of the Sun. Yes - it would be a pain to move it all the time BUT you have to decide IF you want to have it LAST longer. Fortunately the end of MY pool, where the reel resides, is shaded by trees :).
Here is what I have found to work well to heat the water best. Know that heat rises. We have all detected the first few inches of water under the cover is hot. Whilst the Solar pool is on the water, select to have your filter on 'full bottom drain' - the bottom of the pool is where the water is the coldest. The filter will draw the cold water nearest the bottom through the bottom drain sending it back into the pool. As the inlet is closer to the surface of the pool the cold water will then MOVE the hot water - mixing it with the cold water. This then places cooler water just under your cover for solar cover heating. This also helps protect your solar cover from getting too hot. A cover getting too hot will split the layers.
Additionally be mindful to the fact your inlet assembly can be 'adjusted' to direct the water directionally as well as up and/or down. I have my inlet adjusted to direct the water just below the cover but not too close to the surface so that the cover will not 'travel' from the force of the water but yet enough to move that layer of hot water around. This will always supply cool water from the bottom of the pool under your cover.
Of course the bottom drain will help 'pull' the water down also.
P.S. - some of you may 'think' that full skim will draw the hot water through the pool best BUT - because of the location of the inlet being (high on the sidewall of the pool) you will have , by doing this, allowed that cold water to remain at the bottom of the pool. I have tried both ways by the way - my suggestion DOES work BEST!!!
Ummm - there will NOT be a charge for this guidance - a round of applause will do.
getting back to the question

Solar blankets / covers: blue vs. silver back vs. clear

Postby getting back to the question » Sun 20 May, 2012 17:41

Getting back to the original question. I'm trying to figure out a consensus. Looks like clear covers win.
Pool Newbie
Pool Newbie
Posts: 6
Joined: Fri 25 May, 2012 08:30
My Pool: 18 x 36 7/11 pool, 92,000liters, Aqua Genie skimmer, hayward 1 HP pump, original 7/11 24" sand filter
Location: Canada

Solar blankets / covers: blue vs. silver back vs. clear

Postby BillD » Thu 31 May, 2012 14:16

I have only used the clear blue ones, and they work best when on the pool. You really need to look at how they work. The air in the bubble gets heated and water flowing across the cover absorbs the heat. If the heat isn't absorbed the bubbles get so hot they burst. so, it is important to draw heat across the blanket to get maximum heat transfer and extend the life of the blanket. As well, when on the roller, the blanket needs to be covered to protect it from the sun. If you want a dramatic comparison of the difference between a clear/blue cover and a black opaque one, put both on some grass and see what happens. The other thing the covers do is prevent/reduce evaporation,and evaporation cools the water.
Pool Newbie
Pool Newbie
Posts: 1
Joined: Fri 29 Jun, 2012 09:32
My Pool: In-ground, 20x40 gunite, 30 years old, using blue-and-silver solar cover and Hayward Perflex DE filter -- have done plaster repairs.
Location: United States

Solar blankets / covers: blue vs. silver back vs. clear

Postby jstars » Fri 29 Jun, 2012 09:53

I have used clear solar covers up until this year. They heated up the pool really well, but did cause algae to form (but that could have also been because it did such a good job warming the water!).

I started using a Blue-Silvered cover this year and after more than a month of constant covered use (with pump running during the sunniest 6 hours of the day the pool has only gone from 68->78 degrees so far, hitting 80 only once. I like to keep it into the 80s (and in NewEngland you have to Bank as much heat as possible to stretch the short pool season up here).

The idea about pulling more cold water thru the bottom drain and sending it to the top to mix with the warm sounds pretty good. I think my pump system is doing maybe 2/3rds bottom and 1/3 top now anyways. But I might even put a cleaner hose permanently into the skimmer and let it dangle down into the pool bottom so it no longer 'skims' (and maybe does some cleaning down there too).

Thanks for the good ideas on this.


Solar blankets / covers: blue vs. silver back vs. clear

Postby Dmanf » Mon 29 Apr, 2013 17:53

Did an experiment:
I used two identical cold tubs of water and covered on with a translucent blue cover, and I added a black layer to the other. There initial water temperature was 55. By the end of the day, they were 82 degrees. (8x18x4 inches water). POINT: The black plastic over the bubble cover did not affect any change whatsoever. The black may absorb more sunshine, but the opacity prevents solar penetration. All these covers with different color bubbles are marketing, marketing, marketing. I went with blue at half the price (and admittedly half the warranty. The warranty is essentially worthless anyway).
chem geek
Pool Industry Leader
Pool Industry Leader
Posts: 2382
Joined: Thu 21 Jun, 2007 21:27
Location: San Rafael, California

Solar blankets / covers: blue vs. silver back vs. clear

Postby chem geek » Tue 14 May, 2013 15:25

If you were to have compared with a white opaque cover, then there would have been far less rise in water temperature. Basically, the translucent one lets light through that heats the water while the dark opaque cover absorbs the light so gets hot and can heat the water that way though depends on where the black is -- if at the top above the bubbles then heat won't get transmitted very much (and instead it heats the air more than the water) but if on the underside touching the water, then heat should pass to the water.

We have used a light tan opaque electric safety cover on our pool in the past and then switched to a darker blue opaque cover and noticed an increase in water temperature with the latter of a few degrees (but we mostly heat using solar so the temperature difference would be greater if we didn't have any other heating). These are not bubble-type covers so are just comparing the difference in color. The covers are only about half as insulating as a good bubble-type cover which is why the darker one was able to pass heat through to the water.
Chris in upstateNY

Solar blankets / covers: blue vs. silver back vs. clear

Postby Chris in upstateNY » Fri 31 May, 2013 07:09

One of the original questions asked related to heat retention. All the replies seem to only discuss heating capability and impact on chlorine levels.

I have an 18x32 IG in a yard flanked by tall trees on the south and west. Definitely not 8 ours of direct sunlight even at the height of summer. I live on a hill in upstate NY. Gets very hot in the summer, but can get cool at night. I have always found that for me, the cover is more blanket, and less solar heater, in that the key is having it on at night to prevent heat loss. A secondary benefit is having it on during the day on sunny days when the pool is not being used. But for me, that heating function, though important, has been secondary to the blanket function.

My cover just went to the dump. Light blue, round bubbles - no idea what mil. It tore and was taking on water, and became too difficult to take on an off, especially for my wife, thus limiting use.

SO. - I need a new cover and found myself as confused as the original poster. The cover needs to:

1. Retain heat at night (I really don't care why I.e. whether due to evaporation prevention or whatever).
2. Provide solar heating during the day on hotter sunnier days. Note that per Joseph's comment, I do have a floor drain and do not have a dedicated vacuum line).
3. This is a biggie: Be Manageable to take on and off - not too heavy, not difficult to crank on the roller, not too heavy for the roller.
4. Last for at least two seasons for every $100 of cost.

Recommendations as to color, thickness, manufacturer, and design would be appreciated, addressing w
Each of the four criteria. Thanks in advance for any responses.

Chris in Syracuse

Return to “Pool Equipment & Other Pool Maintenance”

Who is online at the Pool Help Forum

Users browsing this forum: No registered users and 1 guest