"pcb" code on aqua rite control panel

SWGs, salt water chlorine generators, chlorinators,
ozone generators, UV systems, . . .
troiab
Pool Newbie
Pool Newbie
Posts: 1
Joined: Sat 23 May, 2009 06:49
My Pool: aqua rite cell

"pcb" code on aqua rite control panel

Postby troiab » Sat 23 May, 2009 07:04

has anyone troubleshot the "pcb" error code on the aqua-rite control panel?
i was hoping someone could direct me in my troubleshooting today. looking for specific failures on the pcb rather than, "sorry sir, an authorized technician will have to replace the whole unit"


lpm623

"pcb" code on aqua rite control panel

Postby lpm623 » Wed 12 Aug, 2009 08:27

The inthruster is the most common problem. It is in the top right corner of the pcb. It is black and size of a quarter. Look for burn marks around where it is soldered or if it is cracked. To find a replacement go online to Digi-Key.com the cost is 2.42 plus shipping! This fixed my problem I hope it helps you.
Guest

"pcb" code on aqua rite control panel

Postby Guest » Wed 12 Aug, 2009 09:09

The current limiter Inrush located in the top right corner of the pcb is the problem I had. Look to see if ther are any burn marks, or if the black disk the size of a quarter is cracked or the solder has come loose. If the disc is bad, a new one can be found at Digi-Key.com The part number is 570-1062-ND The cost is 2.42 plus shipping! This was my problem I hope this helps you Too! Way better than paying a service call or buying a new circuit board.
Gernsey1

"pcb" code on aqua rite control panel

Postby Gernsey1 » Tue 15 Jun, 2010 06:19

Thank you both for this tip! $2.62 vs $299.00 for a new board! Awesome!

Return to “Salt Water Chlorine Generators, Ozone, UV”

Who is online at the Pool Help Forum

Users browsing this forum: oBot [bot] and 0 guests