I have a Mineral Springs MS 10 or 11. The unit display always showed salt in PPM then the Temp. It just stopped. Is that tied to the flow indicator or??????????????
It seems to be working fine other wise but not knowing the salt PPM has cuased me to over load it once so far. Thanks
Mineral Springs Controller not reading PPm & Temp
Mineral Springs Controller not reading PPm & Temp
scd153 wrote:I have a Mineral Springs MS 10 or 11. The unit display always showed salt in PPM then the Temp. It just stopped. Is that tied to the flow indicator or??????????????
It seems to be working fine other wise but not knowing the salt PPM has cuased me to over load it once so far. Thanks
How old is the unit? Have you cleaned the cell? Is the fuse Bad?
Mineral Springs Controller not reading PPm & Temp
internationalpoolsupply.com wrote:scd153 wrote:I have a Mineral Springs MS 10 or 11. The unit display always showed salt in PPM then the Temp. It just stopped. Is that tied to the flow indicator or??????????????
It seems to be working fine other wise but not knowing the salt PPM has cuased me to over load it once so far. Thanks
How old is the unit? Have you cleaned the cell? Is the fuse Bad?
Mineral Springs in an Aqua Rite unit.. You can call Hayward or Aqua Rite to get additional info. If you can't figure it out contact me on my website by email and I will get you some phone numbers of friends that can help.
Mineral Springs Controller not reading PPm & Temp
I have the same problem.
Did you get any answers?
Did you get any answers?
Return to “Problems & Suggestions for this Forum”
Who is online at the Pool Help Forum
Users browsing this forum: No registered users and 3 guests