Huge leak coming from filter head

[Guest]

Hey there,

I am just trying to open up my pool this weekend and installed a brand new pump, upgraded from 3/4 HP to a 1HP. I finally got the system started up and the jets pumping good and the filter head springs a leak. (Above where the rotary type valves seal onto water diversion chambers).
I just had the spider gasket (?) replaced. This leak is where the filter head meets the filter base part and I have tightened the screws to near-stripping and I cannot get the leaks to stop. The water sprays 3-5 feet in all directions.

If anyone can help me out that would be great,
Thanks

zxj@rogers.com

[Pool Helper]

Inspect the o-ring for signs of wear or damage and replace if necessary. You could also try some instant gasket in a tube.

[Guest]

Thanks for the reply, I went out last night into the shed and guess what was sitting on the shelf, the O-ring . Popped that in and works like a charm.

[kshariff]

recently replaced spider gasket, water continues to leak from back flush port. Help!!

[Teapot1]

Open up the multiport and fix the gasket properly

[Denniswiseman]

Is there a chance that you put the head on incorrectly